4. Open the lid. Place spirit level on the flat surface
on the left side, inline with the centre of the bowl.
Adjust the front left foot (wind down) until the
machine is level.
Fig. 6 Levelling - Step 4
5. Move the spirit level to the right side, in line with
the centre of the bowl. Adjust the front right foot
(wind down) until the machine is level, and does
not rock. There should be equal weight on both
front feet so that neither can be turned by hand
when the machine is in position.
Fig. 7 Levelling - Step 5
6. Place the spirit level at the centre front of the
topdeck, forward of the lid lock slot. Check the
machine is level. Move the spirit level around to all
positions once more, checking the machine is level
in all areas. Check the machine does not rock side
to side, front to back, or corner to corner.
Fig. 8 Levelling - Step 6
• Keep your spirit level for the next time you move or reposition your washer.
• If moving or transporting your washer in the future, ensure you tape the lid down beforehand.
Completing your installation
• Turn on the water and check all hose connections for leaks. Make sure there are no kinks in the hoses. Check
the hose connections for leaks again after 24 hours.
https://producthelp.fisherpaykel.com/nz/Wash/Top_Loaders/CleanSmart/WL1068P1/User_Guide_WL1068P1/02_Installation_…
Updated: Sat, 16 Nov 2019 03:22:08 GMT
Powered by
6
To Next Page
Loading...
Need help?
General
