How to attend to a fault - integrated models with badge
START HERE
Press _ to stop the beeping. /
]
Try to open the drawer
(without using excessive force).
YES
NO Press O. Wait a few
seconds, then press
0 again.
Check which program indicators
are lit on the wash program panel.
Look up what fault code the
indicators correspond to in the
tame opposite.
Note down the code here:
o _ o o o
HEAVY NORMAL EAST DELIR,CTE RINSE
Ul:Turn on the water supply,
÷ then press HJ to resume the wash
program.
U4: Attend to the fault on
÷ the other drawer. The drawer
displaying U4 is not faulty.
U6: Open the drawer and check thelspray arm.
Has the spray arm loosened or
come off its mounting?
YES I NO
Refit the spray arm
following instructions
in section 'User
maintenance
instructions', then dose
the drawer and press
Hi to resume the wash
program.
Press O. Wait a few
seconds, then press
0 again.
L__
YES NO, iT'S
GREEN
PressHi. The Eco indicator and another set
of program indicators will briefly light up on
the wash program panel. Mark which ones
in the diagram below. This information will
help Fisher & Payke[ identify the fault more
precisely. Which other indicators fight up
when you press Hi ?
HEAVY NORMAL FAST DELICATE RINSE
YES
To Next Page
Loading...
Need help?
General
