35
Fault codes
Fault codes Possible causes What to do
F1
Flood switch has been
activated.
Turn off the water supply to the
DishDrawer® and call your Authorised
Service Centre or Customer Care.
F2
Motor problem. Call your Authorised Service Centre or
Customer Care.
F3
Temperature sensor
failed.
Ensure water coming in through the inlet
hose is less than 65
o
C. You may need to
install a tempering valve on your water
supply.
F4
Faulty temperature
sensor or element.
Call your Authorised Service Centre or
Customer Care.
F5
Lid fault. Plug the DishDrawer back in or turn it on
at the power supply. Fault may reset.
F6
Lid fault. Plug the DishDrawer back in or turn it on
at the power supply. Fault may reset.
F7
Lid fault. Plug the DishDrawer back in or turn it on
at the power supply. Fault may reset.
F9
Electronics
malfunction.
Call your Authorised Service Centre or
Customer Care.
To Next Page
Loading...
