14
WASH MODIFIERS
Using SANITIZE
The SANITIZE wash modifier adjusts the wash program to meet the conditions required by
Section 6, NSF 184 for sanitization to occur. While SANITIZE is running, the wash program is
monitored to ensure that these conditions are met.
Only programs utilising the
SANITIZE wash modifier are certified to meet the conditions
required by Section 6, NSF 184. Other wash programs may not reach the temperatures
required for sanitization to occur. See table on previous page for wash programs that have
sanitize available.
For sanitization to occur, the temperature of the water needs to reach 70°C. Ensure all
items are dishwasher safe before running the sanitize modifier.
If the wash is interrupted or the water supply is turned off during the program, the heating
conditions for sanitization may not be met. You may need to run the program again.
If sanitization has been successful
The DishDrawer™ Dishwasher will beep,
0
will show in the display and the SANITIZE
indicator will remain lit. After 30 seconds the
display will turn off.
If sanitization has not been successful
An alert will sound and an alert code will
show in the display. The
SANITIZE indicator
will not be lit.
1 Check if the water supply has been turned
off or the wash program interrupted.
2 Press
once to stop the beeping and
then again to clear the alert code.
3 Run the
SANITIZE cycle again.
For more information, refer to 'Fault codes'.
To Next Page
Loading...
Need help?
General
