42
FAULT CODES
‘A’ fault codes
Follow the steps below to try and fix the issue.
DISPLAY POSSIBLE CAUSE WHAT TO DO
A1
Water supply fault. 1 Ensure the water supply is turned on.
2 Press
once to stop the beeping, then
again to clear the fault.
3 Press
to resume the wash program.
A3
Drawer cannot drain. The
drainage hose may be
blocked or kinked, or the
connection to drainage
pipe may be blocked.
1 Ensure the drainage hose and connection to
pipes are not blocked.
2 Press
once to stop the beeping, then
again to clear the fault.
3 Press
to resume the wash program.
A6
The spray arm has
loosened or come off
its mounting, or water
pressure is too low.
1 Open the drawer and check the spray arm.
2 If the spray arm has loosened or come
off its mounting, re-fit it. Check that
it is firmly seated and turns freely.
Refer to 'Maintenance'.
3 Press
once to stop the beeping, then
again to clear the fault.
4 Press
to resume the wash program.
A7
Auto recovery program:
DishDrawer™ Dishwasher
has detected excess
foam in the drawer.
1 Let the auto recovery program run until
it is complete. The wash program will
resume when the auto recovery program
has completed.
2 Check that you are using the right detergent
before running another wash program.
3 If the drawer is still filled with foam at
the end of the wash program, contact
Customer Care.
A09
Sanitize cycle hasn’t met
temperature needed to
sanitize dishes.
1 Check if the water supply has been turned
off or the wash program interrupted.
2 Press
once to stop the beeping, then
again to clear the fault.
3 Run the sanitize cycle again.
To Next Page
Loading...
