User Maintenance Instructions - DD36/DD90 Models
Disconnect the dishwasher from the power supply (unplug or switch off at the circuit
breaker) and allow all its parts to cool before any cleaning or maintenance.
Holiday Time
• If the dishwasher is not going to be used for some time, we recommend you leave it clean and empty. Leave the
drawer ajar to allow air to circulate. Turn off both the power and water supply to the dishwasher.
• When using your dishwasher for the first time after a long period away, we recommend pouring 3 cups of water into
the drawer before loading and starting a wash. This is to lubricate components that may have dried out during non-
use.
Cleaning the Surfaces
1. Wipe with a clean damp cloth. Take care not to wet the control panel.
2. Dry with a clean lint-free cloth.
We do not recommend the use of the following cleaning aids on your dishwasher as they
may damage the surfaces:
• Plastic or stainless steel scouring pads
• Acid or alkaline cleaners
• Stainless steel cleaners or polishes
• Abrasive, solvent, household cleaners
• Hand washing liquids or soap
• Laundry detergents or disinfectants
Cleaning the Drain Filter, Spray Arm and Filter Plate
• We recommend that the drain filter is cleaned whenever there is evidence of food particles.
• The spray arm may need cleaning about once a month in normal use or more often should the need arise.
• The filter plate should not normally need cleaning. Food particles remaining on its surface can be wiped off with a
clean, damp cloth.
https://producthelp.fisherpaykel.com/us/Clean/DishDrawer%E2%84%A2/Single/DD24SCTB7/User_Guide_DD24SCTB7/11_U…
Updated: Tue, 16 Nov 2021 11:52:55 GMT
Powered by
6
To Next Page
Loading...
Need help?
General
