Installation instructions
Please read and follow the ‘Safety and warnings’ and ‘installation instructions’ sections carefully before using
your dryer!
Moving your appliance
If the dryer needs to be placed at an angle for moving, only tip towards the right hand side (when viewed from the
front). If the dryer has not been transported as described, leave it standing upright for at least one hour before
turning on.
Accessories
Please check you received the following accessories with your Fisher & Paykel dryer. You will find them inside
the drum:
• 1 x Drying rack
• 1 x Drain hose
• 1 x Installation instructions and user guide
Unpacking
To ensure the best performance from your new dryer please follow the instructions below.
Removing the packaging
1. Remove the outer packaging (including the polystyrene packer and plastic wrapping). All packaging must be
removed prior to use.
2. Tilt the machine backwards and ‘walk’ it off the base one foot at a time. Not doing so may cause damage to
your floor and dryer.
3. Remove all packaging and accessories from inside the drum and ensure you remove protective covers from
door and console.
https://producthelp.fisherpaykel.com/nz/Dry/Dryers/Heat_Pump/DH8060P1/User_Guide_DH8060P1/03_Installation_instructions
Updated: Sat, 10 Dec 2022 09:57:54 GMT
Powered by
1
To Next Page
Need help?
General
