L(2,2) -1- 599618C DD24D install A2 USCA.indd 15/4/09 10:01:39 AM
I
OPTIONALW HARD WIRING THE PRODUCT
Ensurethe drawer is removed
and then rotated counter-
clockwise to prevent kinked
hoses.
Access cover
Remove knock-out for cable
clamp. Fit suitable cable clamp
for the conduit and terminate
the wiring asshown.
Use copper
conductors only.
Remove the
access cover
Remove Power supply
Ensure the drawer clips on c,/...._.,_
both sides are reset.
Ensure the drawer
is now rotated
clockwise back.
©
Before refitting the drawer,
ensure the hoses are not
twisted and the latches at
the rear of each drawer
runner are facing forward.
To Next Page
Loading...
