Fisher & Paykel DishDrawer DD24D Series - Water Supply

L(2,1) -1- 599618C DD24D install A2 USCA.indd 15/4/09 10:01:39 AM
PARTS SUPPUED
Drain hose Drain hose Wire clip (2) Clamp (1) Top Phillips Washer (1) Moisture protection Edge protector (1) Hexagonal Prefinished toekick (I)
support (1) joiner (1) mounting 16 mm tape (1) (if serviceshole socket (2) white or black
brackets (2) screws (9) (to prevent moisture partition ismetal) (long & short)
d_m_ge)
Ifthe Drain hose(s) supplied are not long enough to reach your services, you must use a Drain Hose Extension Kit P/N 525798 which will extend the drain hose(s) by 1I' 10"(3.6 m).The kit isavailable from the nearest
Fisher& Paykel Authorized Service Agent, or Toll free 1.888.936.7872 or www.fisherpaykekcom.
CAVKY PREPARATION
$6
Importand
Besure the edgesof the serviceshole aresmooth orcovered,ff the services
hole isthrough a metal partition the hole must beprotected with the Edge
protector supplied to prevent damage to thepower cord orhoses.
These marks indicate mounting bracket screw locations
Preferred position. If adequate clearance, services hole can be
higher to clear toekick space.
If hole is higher, ensure drain hose(s) are routed straight into the
waste connection.
Water Connection
Recommended HOT (Maximum 140°F/60°C).
Supplied hose to suit 3/8" (9 ram) male compression fitting.
If no side partition, use a
brace for securing.
Water Pressure Max Min
Water softener models 1 MPa (145 psi) 0.1 MPa (14.5 psi)
Other models 1 MPa (145 psi) 0.03 MPa (4.3 psi)
Drains will need to be separated to satisfy kosher requirements. We suggest you confirm
acceptability with your local rabbi in respect to kosher installations.
Drain hose
Inlet hose
Power cord (excl.plug)
78 ½" 70 ½"
(2000mm) (1800 ram)
64 ¾"
(1650 mm)
29 ½"
(750 mm)
49"
(1250 ram)
27 ½"
(700 mm)
Left hand
side
Right hand
side
(10 mm) ta
max. o 1 1/2"
(38 mm)
\
Water supply
J
i
_min. 7 Ys"
(200 mm)
max. 17 11A6"
(450 mm)
z?i\t
110-120VAC
max. 15 A