32
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE WHAT TO DO
Foaming Incorrect amount or type of
detergent used.
Refer to 'Detergent' or consult the
detergent manufacturer’s instructions.
Too much egg in the
wash load.
Increase the amount of detergent.
Rinse aid dosage level
too high.
Decrease the rinse aid dosage.
Rinse aid spills not wiped up. Ensure that all rinse aid spills are wiped
up when they occur.
The dish washer
stops suddenly
during the wash
Power or water supply has
been interrupted.
Check the power and water supplies.
Knocking or
rattling sound
during wash
Spray arm knocking
against dishes.
Pause the wash and rearrange dishes.
Refer to 'Setting a wash'
and 'Loading suggestions'.
Dishes have been
stacked incorrectly.
Unclean dishes Unsuitable wash program for
load selected.
Select the appropriate wash program for
the load. Refer to 'Wash programs'.
Soils were too heavily
baked on.
Dishes may need soaking.
Spray arm(s) unable
to rotate.
Ensure no items are obstructing the spray
arm path.
Basket/rack
incorrectly loaded.
Refer to 'Loading suggestions'.
Filter plate or filter
incorrectly installed.
Refer to 'Maintenance'.
Detergent put in the
wrong compartment.
Refer to 'Wash programs' and 'Detergent'.
Excessive food not removed
from dishes before loading.
Scrape all food scraps off dishes
before loading.
Unsuitable detergent. Only use powdered or tablet detergent
designed for domestic dishwashers.
Not enough detergent. Refer to 'Detergent' for recommended
quantities. You may need to adjust these
to suit your particular load and the
hardness of your water supply.
Spray arm holes are blocked. Clean the spray arm(s). Refer to
'Maintenance' for instructions.
The filters are blocked. Clean the filters. Refer to 'Maintenance'
for instructions.
To Next Page
Loading...
Need help?
General
