35
FAULT CODES
How do I know if there is a fault?
Your dishwasher will beep continuously and a fault code will flash in the display. There are
two types of fault codes – ‘F’ and ‘A’.
To fix a fault
First try to fix the issue and clear the code according to the steps in the following tables.
If the problem persists:
1 Note down the fault code.
2 Contact Customer Care for support or to organize a visit by a service technician. Refer
to the Service and Warranty booklet for contact details.
'F' fault codes
You may be able to clear the fault by resetting the dishwasher. Follow the steps below
3 Press and hold
CANCEL to stop the beeping, then again to clear the fault code.
4 Wait a few seconds, then press
to turn the dishwasher back on.
If the fault code has disappeared, the fault has been reset and you can continue to use
your dishwasher.
To Next Page
Loading...
Need help?
General
