36
FAULT CODES
PROBLEM POSSIBLE CAUSE WHAT TO DO
A20
Drain fault
Drain hose is crimped
or bent.
Check the drain hose and straighten if needed.
Blocked
drain connection.
Check that drain connection is free from blockages.
The waste water is not
draining out.
Ensure that the drain hose is connected in accordance with the
installation instructions.
The turbidity
sensor is dirty and
requires cleaning.
Gently clean the turbidity sensor with a soft brush
(ie toothbrush) to remove any buildup.
Turbidity
sensor
Drain pump is blocked. Remove the drain filter and clear any water from the drain.
Remove the sump insert and pump cover.
Remove any remnants of food or blockages from the pump.
Take care in case sharp objects or fragments of glass are
blocking it, as these may cause injury.
Pump
cover
Sump
insert
A10
No water
Water tap not
turned on.
Ensure the water is connected and turned on.
Touch
to restart the dishwasher.
Insufficient water
supply pressure.
Check household water pressure.
Water inlet hose is
crimped or bent, so no
or not enough water
gets to the dishwasher.
Check the water inlet hose and straighten if needed.
Touch
to restart the dishwasher.
Drain hose is not
connected correctly.
Ensure that the drain hose is connected in accordance with the
installation instructions.
'A' fault codes
Follow the steps below to try and fix the issue.
To Next Page
Loading...
Need help?
General
