Need help?Do you have a question about the Fisher & Paykel Ecosmart GWL15-US-96200 and is the answer not in the manual?
General| Type | Top Load Washer |
|---|---|
| Energy Star Certified | Yes |
| Spin Speed | 1000 RPM |
| Color | White |
| Configuration | Freestanding |
| Number of Programs | 6 |
| Control Type | Electronic |
| Display | LED |
| Voltage | 120 V |
| Frequency | 60 Hz |
Detailed description and identification of the motor control module.
Detailed information about the motor, including stator and rotor.
Troubleshooting steps for out-of-balance conditions.
A table mapping diagnostic levels to displayed information.
Lists and explains specific fault codes and their primary causes.
Details fault codes related to the motor control module's operation.
Explains errors related to the machine's size setting.
Troubleshooting for thermistor errors and temperature sensing issues.
Explains flood protection errors and their causes.
Details fault codes related to water leaks and siphoning.
Explains errors indicating a blocked pump or drain issue.
Details faults related to the pressure sensor and its connections.
Explains issues with the pressure tube, such as blockages or disconnections.
Faults related to the basket not disengaging correctly.
Faults indicating the thermistor is measuring incorrect temperatures.
Errors detected during the display module's memory check.
Faults related to the display module's EEPROM.
Faults indicating faulty coils in the hot and cold water valves.
Faults indicating the cold water valve coil is faulty.
Faults indicating the hot water valve coil is faulty.
Faults related to the diverter valve not functioning correctly.
Faults indicating issues with the diverter valve during top-up cycles.
Faults where a valid basket status cannot be determined.
Faults indicating the pressure transducer reading is too high.
Faults indicating the pressure transducer zero reading is too low.
Faults indicating drift in the pressure transducer's characteristics.
Errors in communication between the display and motor control modules.
Communication errors between display and motor control modules.
Faults where the motor control module resets unexpectedly.
Over-temperature fault for the AC pump triac.
Errors related to the rotor position sensor's signal.
Faults indicating the motor is unable to start.
Faults where the basket re-engages during agitation.
Faults indicating an open circuit in the lid lock or its harness.
Faults indicating a short circuit in the lid lock.
Errors related to continuity problems with the temperature sensor.
Faults related to the Hall sensors in the RPS.
Failure during the motor step test, indicating RPS or wiring issues.
Faults detected during motor bridge electronics testing.
Procedure for clearing blockages in the drain pump.
Common causes and checks for flooding or leaking issues.
To Next Page