21
d
I
I
I
I
I
I
I
I
I
I
I
ABNORMAL SITUATIONS AND/OR OPERATION PROBLEMS
during cooking or the self cleaning cycle.
1. 30 F0 or 30 F1 appear during the cooking or self cleaning cycle
Oven temperature sensor broken or not working properly. The cooling fan stays on
and if the self cleaning cycle is in progress the door remains locked.
What to do:
1. Turn the oven function selector to
OFF (oven OFF). A 30 minute countdown will
start. If the selector is turned and then returned to
OFF the count will start again from
30.
2. Wait for the countdown to finish.
The fan switches off and the door, if locked, unlocks.
3. Disconnect the range from the mains and contact the After-Sales Service Centre
because the oven can no longer be used.
Caution: If the function selector is not turned to
OFF (oven OFF), the cooling fan will
continue to work and the oven door, if locked, remains locked.
2. F0.00 appears during the self cleaning cycle
This indicates a temperature sensor measurement error during the self cleaning
cycle. This may be due to the self cleaning cycle being stopped and started again
when it was quite a way through.
What to do:
1. Turn the oven selector knob to OFF (oven OFF).
2. Wait for at least 15 minutes before repeating the operations to start the self cleaning
cycle.
3. If the message is still given after several attempts call the After-Sales Service.
3. Display OFF - Oven not working properly.
What to do:
1. Turn the function selector to
OFF (oven OFF)
2. Wait for the oven to cool down completely so that the door opens
3. Switch the range off for a few seconds.
If after this procedure the display is still off:
4. Disconnect the range from the mains.
5. Call the Service Centre. The range must not be used.
4
To Next Page
Loading...
Need help?
General
