23
4
PROBLEMS ON STARTING AND DURING THE SELF CLEA-
NING CYCLE
1. “door” (fl ashing) appears on the programmer display
The function selector has been turned to the self cleaning position with the oven
door open or not perfectly closed. Or the door has been opened before the cycle
has been started with confi rmation from .
What to do:
• Close the door and repeat the operations to start the cycle.
2. “F0E0” and “A” appear on the programmer display
The self cleaning cycle has been stopped and then re-started (immediately).
The message is displayed after about 15 minutes and the self cleaning cycle is
zeroed.
What to do:
• Turn the oven selector dial to
OFF (oven off).
• Wait for at least 30 minutes.
• Repeat the operations to start the self cleaning cycle.
• If after several attempts the message continues contact the Service Centre.
Caution: It is advisable not to stop the self cleaning cycle and then start it again
when it is quite a way through.
3. “Fdor” appears on the programmer display
Malfunctioning of the door lock system.
What to do:
• Turn the function selector to
OFF
(oven OFF).
• Wait for the oven to cool down completely and disconnect the range from the
mains.
• Reconnect the appliance to the main.
If after this procedure the display still reads “Fdor”:
• Disconnect the range from the mains.
• Call Service. The range must not be used.
A
A
I I I I I I I
I
I
I
I
I
I
I
I
I I I I I I I
I
I
I
I
I
I
I
A
I I I I I I I
I
I
I
I
I
I
I
I
I I I I I I I
I
I
I
I
I
I
I
To Next Page
Loading...
Need help?
General
