Fisher & Paykel RS36W80 series - 84 Cavity - Attach Anti-Tip Bracket; Wooden;Plaster Board Wall; Solid Wall; Spacer Installation

17
8 84” (2134mm) CAVITY – ATTACH ANTI-TIP BRACKET
IMPORTANT!
Safety requires refrigerators be stable when door and/or drawer, are open. The anti-tip bracket and fittings supplied must be fitted to the wall of the finished enclosure to withstand
a220.5lb (100kg) load. This will prevent the possibility of the appliance tipping forward, when door and/or drawer, are open.
WARNING!
Failure to follow instructions can lead to serious injury or death.
When fastening with masonry plugs and/or screws:

Ensure the screws avoid electrical, gas and water conduits.

Ensure the surface the bracket is fastened to withstands a 220.5lb (100kg) load.

Ensure light-weight masonry material such as cinder block and new concrete (no curing time) are not used in installation.

Do not use metallic materials that may corrode, stain and/or damage the enclosure
A
23/8” min.
(60mm)
overlap
Bracket
PROFILE VIEW
Subtract 61/2” (164mm) from above
finished enclosure
C
23/8” min.
(60mm)
overlap
Bracket
PROFILE VIEW
Subtract 61/2” (164mm) from above
finished enclosure
Spacer
B
23/8” min.
(60mm)
overlap
Bracket
PROFILE VIEW
Subtract 61/2” (164mm) from above
finished enclosure
Spacer installation
If a minimum 23/8” (60mm) overlap cannot be achieved we recommend
fastening a solid spacer (wooden beam etc) behind the bracket.
1
Ensure the length of the spacer corresponds to the enclosure’s width. Always
secure the spacer to existing studs on the enclosure wall (refer toC).
2
Fix bracket to the spacer with screws x4 (#10 x 40 pan head Phillips screws).
Ensure screws hold tight and the bracket overlaps the appliance when it is
positioned (23/8”min. (60mm)) for a secure hold.
Solid wall installation
1
Project the end of the above finished enclosure to the center of the back wall and
subtract 61/2” (164mm). This will locate the contact surface between the bracket
and the appliance (refer toB).
2
Mark screw locations to drill Ø1/4” x 13/8” (Ø 6mm x 35mm) deep holes. Hammer
masonry plugs into the wall until flush x4. Fix bracket to the wall with screws x4
(#10 x 40 pan head Phillips screws). Ensure screws hold tight.
For 84” (2134mm) cavity installation
Wooden/plaster board wall installation
1
Project the end of the above finished enclosure to the center of the back wall and
subtract 61/2” (164mm). This will locate the contact surface between the bracket and
the appliance (refer toA).
Ensure a structural beam/wall stud closest to the center of the wall enclosure is located.
2
Fix bracket to the wall with screws x4 (#10 x 40 pan head Phillips screws).
Ensure screws hold tight and the bracket overlaps the appliance when it is positioned
(23/8” min. (60mm)) for a secure hold.