Fisher & Paykel RS90A1 - Anti-tip Bracket Engagement; Appliance Centering

CAVITY PREPARATION
900MM ACTIVESMART™ SLIDE-IN REFRIGERATOR
Model no:
RS90A1 (Panel Ready)
Cavity Dimensions
mm
a Overall height of cavity**
1800
B Overall width of cavity
when adjoining cabinetry can share 4mm door gap
900
when adjoining cabinetry cannot share 4mm door gap
904
c Overall depth of cavity
650
Specifications
RS90A1
Electrical
Supply
20 VAC, 50 Hz
Service
10 amp circuit
NOTE: Recommended that the electrical & water connection be located in an
adjacent cabinet to either side of the fridge or above the fridge cavity.
Do not locate water or electricity in this area, keep clear of connections.
CAUTION: Central area can only fit water outlet and electrical plug if they are
placed within a recessed cavity.
* In this location the water tap needs to be recessed into the wall, the recess
must allow for an 80mm bend radius for the water tube.
** Allow for height of plinth if using Alternative Installation method (see page
4 for details). Raise location of electrial connections by height of plinth.
A
B
C
REAR OF CAVITY
ISO VIEW OF CAVITY
IMPORTANT NOTE: Throughout this guide, dimensions may vary by ±2mm
(/2
''). Please read the installation manual for detailed information on
installing the product. www.fisherpaykel.com
!
987_FP_2016-02-16