Lit. No. 41298, Rev. 01 February 15, 2019
15
SYSTEM OVERVIEW – HYDRAULIC UNIT
Insta-Act
®
HYDRAULIC UNIT
The HT Series™ hydraulic unit has blade scrape
lock circuitry built in. This feature is activated when
the blade is in FLOAT. The HT Series blade is
raised in approximately 4 seconds and angled side
to side in approximately 3 seconds.
Drain Plug
Quill
Reservoir
Valve Manifold
Breather/
Fill Plug
Motor
Sleeve Bearing
Pump Shaft Seal
Scrape Lock
Bypass Check Valve
Pump Pressure
Breather
Reservoir
O-Ring
Drain Plug
Suction Filter
Pump
Quill
PS Crossover Relief Valve
Solenoid Cartridge Valve
Solenoid Coil
Coil Nut
Poppet Check Valve Kit
Check Valve
Crossover Relief Valve
Valve Manifold Block
Motor
Magnet
Plate Baffle
Retainer Clip
Inlet Fitting
To Next Page
Loading...
