Fisher HT Series - Security Guard System Operations

Lit. No. 41298, Rev. 01 February 15, 2019
21
HAND-HELD CONTROL WITH SECURITY GUARD™ SNOWPLOW ANTI-THEFT SYSTEM
SECURITY GUARD System
Activation & Establishing a 4-Digit Security Code
NOTE: The snowplow must be attached to the
vehicle, and all the electrical connections must
be connected prior to activating the security
code function.
1. Turn the vehicle ignition switch to the "ON" or
"ACCESSORY" position. (It is not necessary to
start the vehicle.)
2. Verify that the control power indicator is OFF.
If the power indicator light is red, the control
is ON. Press the ON/OFF button to turn the
hand-held control OFF.
3. To activate the SECURITY GUARD mode,
press the control #1 button four consecutive
times, and then press the #4 button four
consecutive times (sequence: 1, 1, 1, 1, 4, 4, 4,
4). The green FLOAT light will fl ash quickly and
the red POWER light will turn ON indicating
the system is ready to accept your 4-digit
security code. Enter your 4-digit security code
by pressing any of the eight following buttons
in any sequence: UP, DOWN, LEFT, RIGHT, 1,
2, 3, or 4.
Once you have entered your 4-digit security
code, the FLOAT light will stop fl ashing and the
POWER light will turn OFF. This indicates that
your 4-digit security code is entered and stored
in the SECURITY GUARD system.
Manual Unlock
If the SECURITY GUARD system is activated and
you are using a HT Series™ control with a different
4-digit code than the established security code,
you will be required to manually enter the 4-digit
security code before operating a locked snowplow.
1. Turn the vehicle ignition to the "ON" or
"ACCESSORY" position.
2. Turn the control ON.
3. The POWER light will fl ash rapidly, indicating
that the snowplow is locked.
4. Enter the 4-digit security code.
5. After entering the correct security code, the
POWER light will change from fl ashing rapidly to
a solid light to indicate the snowplow has been
successfully unlocked.
4. Once a 4-digit security code is established,
the SECURITY GUARD system will recognize
any control that has been programmed with
the same 4-digit security code. If a control
not programmed with the correct 4-digit
security code is connected to the system,
the established security code will have to be
entered manually before the snowplow can be
activated (see the Manual Unlock procedure).
NOTE: If the control POWER button is turned ON
prior to completing the programming procedure,
your 4-digit security code will be cancelled.
NOTE: If the plow/vehicle electrical connection
is lost or disconnected, the SECURITY GUARD
system will reset, requiring any HT Series control
that is not programmed with the established
4-digit security code to manually re-enter the
security code to activate the snowplow.
Clearing an Established 4-Digit Security Code
1. Turn the vehicle ignition switch to the "ON" or
"ACCESSORY" position.
2. If the snowplow is locked (the control POWER
light will be fl ashing at a fast rate), unlock the
snowplow by following the Manual Unlock
procedure.
3. Turn the control OFF. Verify that the power
indicator is OFF.
4. With the control OFF, press the #2 button
four consecutive times, and then press the #3
button four consecutive times. This sequence
(2, 2, 2, 2, 3, 3, 3, 3) will clear the 4-digit
security code from the SECURITY GUARD
system. The FLOAT light will fl ash to indicate
that the 4-digit security code was cleared.
NOTE: To enter a new 4-digit security code see
Activation & Establishing a 4-Digit Security
Code.