Fisher HT Series - Page 20

Lit. No. 41298, Rev. 01 February 15, 2019
20
HAND-HELD CONTROL WITH SECURITY GUARD™ SNOWPLOW ANTI-THEFT SYSTEM
Smooth Stop
The control automatically allows the blade to coast
to a stop when the button is released. This results
in smoother operation, reduces the shock to the
hydraulic system, and increases hose and valve
life.
Control Functions
Raise, Lower, Float, Angle
The four diamond-shaped buttons in the center of
the control face, when pressed, will result in the
blade movements described in the table.
Function Description of Operation
RAISE
Press this button to raise the snowplow and
cancel the FLOAT mode. Function times out
after 4.8 seconds.
LOWER
Press this button to lower the snowplow.
Release the button to stop blade at desired
height.
FLOAT
Press the LOWER button and hold 3/4 second
to activate this mode. The FLOAT light in
the upper left corner of the control face will
illuminate. The blade will lower to the ground
surface and follow the contour of the surface
as it dips or raises. Function does not time out,
but control will shut down after 20 minutes of
nonuse.
Press RAISE button momentarily to cancel
FLOAT. Angling left or right will not interrupt
(stop) the FLOAT function.
L
(Angle
Left)
Press this button to angle the blade to the left.
Function times out after 9.6 seconds.
R
(Angle
Right)
Press this button to angle the blade to the
right. Function times out after 9.6 seconds.
1 & 4
Used to access the SECURITY GUARD
system activation mode.
2 & 3
Used to clear the entered SECURITY GUARD
system code.
NOTE: If control function times out before desired
blade movement is complete, release button and
press again.
RAISE
LOWER
R
L
ON/OFFFLOAT
1
43
2
FLOAT Light
(green)