Lit. No. 41298, Rev. 01 February 15, 2019
24
JOYSTICK CONTROL WITH SECURITY GUARD™ SNOWPLOW ANTI-THEFT SYSTEM
Smooth Stop
The control automatically allows the blade to coast
to a stop when the lever returns to center position.
This results in smoother operation, reduces the
shock to the hydraulic system, and increases hose
and valve life.
Control Lever Movement
From the center position, the control lever can
be moved in one of eight (8) directions to control
various movements of the snowplow blade.
To change from one movement of the blade to
another, the control lever must be moved back to
the center position before selecting the desired
function. Whenever the lever is released, it should
spring back into the center position to stop any
blade movement.
Control Functions
Raise, Lower, Float, Angle
Moving the control lever in straight lines up and
down or from side to side on the control body will
result in the blade movements described in the
following tables.
NOTE: If control function times out before
desired blade movement is complete, release
the lever to the center position, then move
back into the desired function.
L
R
RAISE
LOWER
ON / OFF
FLOAT
1
2
34
FLOAT Light
(green)
Function Description of Operation
RAISE
Move the control lever toward the top of the
control body to raise the snowplow and cancel
the FLOAT mode. Function times out after
4.8 seconds.
LOWER
Move the control lever toward the bottom
of the control body to lower the snowplow.
Release the lever to stop blade at the desired
height.
FLOAT
Move the control lever to the LOWER position
and hold 3/4 second to activate this mode. The
FLOAT light in the upper right corner of the
control face will illuminate. The blade will lower
to the ground surface and follow the contour of
the surface as it dips or raises. Function does
not time out; however, control will shut down
after 20 minutes of nonuse.
Move lever to the RAISE position momentarily
to cancel FLOAT. Angling left or right will not
interrupt (stop) the FLOAT function.
L
(Angle Left)
Move the control lever straight to the left to
angle the blade left. Function times out after
9.6 seconds.
R
(Angle
Right)
Move the control lever straight to the right to
angle the blade right. Function times out after
9.6 seconds.
1 & 4
Used to access the SECURITY GUARD
system activation mode.
2 & 3
Used to clear the entered SECURITY GUARD
system code.
To Next Page
Loading...
