Fisher RS-2010 - Fisher RS-2010 Specifications; Power Amplifier Section; Preamplifier Section; FM Tuner Section

a FISHER RS-20TC)
SPECIFICATIONS
POWER AMPLIFIER SECTION
Continuous RMS sine wave power per channel
within stated bandwidth at no more than stated
distortion and with 8 ohm load 100 Watts
Power Bandwidth
20 Hz - 20 kHz
Total Harmonic Distortion at rated power 0.03 %
I.M. Distortion
0.03 %
Speaker Damping
>40
PREAMPLIFIER SECTION
Frequency Response
Phono (30 Hz — 15 kHz)
±0.5 dB
Aux (20 Hz-20 kHz) ±0.5 dB
Input Sensitivity and Impedance
Phono 1,2
2 mV/50 k£2
Tape Monitor 1,2
150 mV/100 k£2
Auxiliary 150 mV/100 k£2
Output Voltage and Impedance
Tape Out (Rated Output) 150 mV/5 k£2
Graphic Equalizer
50 Hz
±10 dB
250 Hz
±10 dB
1 kHz
±10 dB
4.5 kHz
±10 dB
15 kHz
±10 dB
Filters
Subsonic at 10 Hz (18 dB/Oct.) —10 dB
Loudness Contour (100 Hz/10 kHz) +8 dB/+4 dB
Hum and Noise (IHF A Weighted, Inputs Shorted)
Phono 1,2
76 dB
Aux/Tape Monitor 1,2
90 dB
FM TUNER SECTION
Usable Sensitivity
Mono
1.7 /XV/9.8 dBf
Stereo
4.3 MV/17.9 dBf
50 dB Quieting Sensitivity
Mono
2.5 jLlV/1 3.2 dBf
Stereo
34 fXV/35.9 dBf
Signal-to-Noise Ratio
Mono/Stereo
75/70 dB
Capture Ratio
0.8 dB
Alt. Channel Selectivity (±400 kHz) 80 dB
Image Response Ratio
90 dB
Spurious Response Ratio
100 dB
IF Response Ratio
100 dB
AM Suppression Ratio
65 dB
Total Harmonic Distortion at 65 dBf
Mono/Stereo
0.1/0.2%
T.H.D. at 50 dB Quieting Sensitivity
Mono/Stereo
0.3/0.4 %
Stereo Separation
(100 Hz/1 kHz/10 kHz)
40/50/40 dB
Sub-Carrier Product Rejection
(19/38 kHz)
65/70 dB
Audio Frequency Response
(20 Hz - 15 kHz)
±0.5 dB
AM TUNER SECTION
Usable Sensitivity
300/iV/m
Selectivity (±10 kHz)
40 dB
Signal-to-Noise Ratio
55 dB
Image Response Ratio
50 dB
IF Response Ratio
45 dB
GENERAL
120 V AC ±10%
Power Requirements (50/60 Hz)
400 W/500 VA
AC Outlets
2
Dimensions WxDxH 20-5/16”x14-1/4”x6-11/16”
Weight
36 lbs.
* Specifications are subject to change without notice.
2