Fisher RS-2010 - Maintenance

MAINTENANCE
CAUTION:
Turn off the receiver and disconnect its power cord from the electrical outlet whenever instructed to do so in the following
procedures. Do not attempt any maintenance not listed in this section. For further service, consult your Fisher dealer, local
Fisher Service Center, or Service Department, Fisher Corporation.
(If returning your unit for service, please do not include this OPERATING INSTRUCTIONS Manual, the Service Manual, or
the dipole antenna.)
CLEANING THE RECEIVER'S EXTERIOR
The receiver’s control panel and wood-grain vinyl-clad cover
will retain their color and brilliance permanently. However,
it is possible that, over a period of time, a film from atmo¬
spheric contamination may dull the surfaces. Simply use a
soft, freshly laundered cloth moistened with plain lukewarm
water to wipe the surfaces clean and your receiver will look
like new again. Do not use any household or industrial
cleaning agents, or any cloth that has been used to apply such
agents.
2) Turn the fuseholder cap counterclockwise until it dis¬
engages from the receptacle, and remove the fuse from
the cap.
3) Obtain a replacement fuse whose electrical rating is iden¬
tical to that marked next to the fuse receptacle or stamped
on the original fuse itself.
4) Insert the replacement fuse in the fuse cap. Push the cap
into its receptacle and turn it clockwise until it is firmly
in place. Connect the power cord to the electrical outlet
and turn the receiver on.
REPLACING FUSES
CAUTION:
If the TROUBLE-SHOOTING GUIDE in this OPERATING
INSTRUCTIONS Manual indicates that a malfunction may be
caused by a blown fuse in the rear of the set, proceed as
follows:
1) Turn off the receiver and disconnect its power cord from
the electrical outlet.
If the malfunction persists or recurs within a short time,
do not attempt to replace the fuse again. Consult your dealer,
or local Fisher Service Center, or Fisher Corporation.
t
f*
•K
10