Controls Controls on on
the the Front Front PanelPanel
1. 1.
POWE POWE
R R SwitchSwitch
By By
gently gently
pushing pushing
the the
power power
switch, switch,
the the unit unit
is is
switchedswitched
on. on. The The dial dial and and
meter meter
lights lights
will will
light light
when when
the the unit unit isis
switched switched on.on.
Approximately Approximately 5 5
seconds seconds
after after the the
power power
switch switch
is is de-de-
pressed pressed
the the
unit unit is is
ready ready for for use. use. To To
switch switch
off, off,
depress depress
thethe
power power
switch switch
again. again. The The
dial dial and and
meter meter lights lights
will will
go go
out.out.
2. 2.
FUNCTION FUNCTION SelectorSelector
Selection Selection of of the the following following
program program
sources sources can can be be donedone
with with
this this
selector:selector:
7. 7.
SIGNAL SIGNAL Strength Strength MeterMeter
This This meter meter
shows shows
the the relative relative signal signal
strengh strengh of of thethe
received received
signal. signal. When When
a a directional directional antenna antenna
with with rotorrotor
is is used, used, observation observation
of of this this meter meter
will will show show the the
bestbest
direction direction
when when
the the
strongest strongest
indication indication
on on the the
meter meter isis
reached.reached.
8. 8.
TUNING TUNING
MeterMeter
For For best best reception reception
of of an an FM FM
signal, signal, the the
middle middle of of thethe
signal signal
must must
be be
turned turned
in. in. The The
pointer pointer
will will first first
swingswing
from from one one direction direction to to
the the other other and and
when when
the the needle needle
isis
located located
in in the the
middle middle of of the the
field, field, the the
signal signal is is
beingbeing
received received
properly.properly.
L L STEREO STEREO
IndicatorIndicator
This This
indicator indicator lights lights
automatically automatically
when when
the the FUNCTIONFUNCTION
selector selector is is in in the the FM FM
AUTO AUTO or or FM FM
MUTING MUTING
position position
andand
. .
a a stereo stereo broadcast broadcast is is received. received.
The The light light
will will
go go
out out if if thethe
MODE MODE
switch switch is is
placed placed
in in the the MONO MONO
position.position.
10. 10. Preset Preset
Tuning Tuning
Screws Screws
(inside (inside
the the hole)hole)
Facilities Facilities are are
provided provided
for for
the the
pre-selection pre-selection
of of up up to to t t
tOtO
programs programs
by by
adjusting adjusting with with the the driver driver
supplied.supplied.
To To tune tune the the
stations, stations,
proceed proceed
as as follows:follows:
(1) (1)
Select Select the the FM FM
MUTING MUTING
by by turning turning the the FUNCTIONFUNCTION
selector.selector.
(2) (2)
Set Set the the FREQUENCY FREQUENCY
LOCK LOCK
switch switch
to to
OFF.OFF.
(3) (3)
Touch Touch
"on" "on" ofthe ofthe 5 5
pre-set pre-set
controls.controls.
(4) (4)
Tune Tune in in the the
required required
station station using using
the the
correspondingcorresponding
Preset Preset
Tuning Tuning
screw screw by by
adjusting adjusting
with with the the
driverdriver
supplied.supplied.
11. 11.
FM FM
STATION STATION
Touch Touch KeysKeys
To To receive receive
an an
FM FM
station station
which which
has has been been
pre-tuned pre-tuned
withwith
the the Preset Preset
Tuning Tuning
screw screw
by by adjusting adjusting
with with
the the
driver driver
sup-sup-
plied, plied,
simply simply
touch touch
the the key key corresponding corresponding to to
the the
station.station.
The The red red indicator indicator above above the the key key
will will light light up.up.
12. 12.
FM FM MANUAL MANUAL
Touch Touch
KeyKey
Extra Extra
program program
source source
(i.e. (i.e.
televisiontelevision
audio audio
signal).signal).
- -
PHONO: PHONO: Records Records from from turntable turntable
using using movingmoving
magnet magnet type type
cartridge cartridge
systems.systems.
- -
FM FM AUTO: AUTO:
When When a a stereo stereo
FM FM
broadcast broadcast is is received.received.
the the stereo stereo
indicator indicator lights lights up.up.
- -
FM FM
MUTING: MUTING:
Mutins Mutins eliminates eliminates noise noise that that occursoccurs
- -
MW:MW:
_ _
LW:LW:
between between
FM FM
stations. stations. Muting Muting can can
alsoalso
block block out out weak weak stations stations
which which would would
notnot
normally normally
give give good good
results. results. If If
you you
wishwish
to to listen listen
to to
a a
weaker weaker station station
which which isis
muted muted out, out, select select
the the function function
selectorselector
into into
the the
FM FM
auto auto
position.position.
In In this this
position position
the the
AM AM
frequency frequency rangerange
of of
520 520 to to 1605 1605
kHz kHz can can be be received.received.
In In this this
position position
the the
AM AM
frequency frequency
rangerange
of of
150 150 to to 350 350
kHz kHz
can can be be received.received.
3. 3.
VOLUME VOLUME
/BALANCE /BALANCE
ControlsControls
The The BALANCE BALANCE
control control knob knob
is is used used
to to
adjust adjust the the
audioaudio
balance balance of of a a
stereo stereo
program program
source, source, turn turn the the
outer outer controlcontrol
knob knob
to to either either the the right right
or or
left. left.
The The normal normal
position position
hashas
detent detent
in in the the middle.middle.
4. 4. TONE TONE
ControlsControls
BASS BASS
ControlControl
When When
adjusted adjusted to to the the
middle middle
position, position,
the the
sound sound
qualityquality
is is linear. linear.
When When the the
control control
is is turned turned
to to the the
right, right, bassbass
frequencies frequencies
will will
be be increased, increased,
when when
turned turned
to to the the leftleft
these these same same frequencies frequencies
will will be be decreased.decreased.
TREBLE TREBLE
ControlControl
When When adjusted adjusted to to the the middle middle
position, position,
the the
sound sound
qualityquality
is is
linear. linear. When When the the
control control
is is turned turned to to
the the right, right,
trebletreble
frequencies frequencies
will will
be be increased. increased. When When
turned turned to to the the left left
thesethese
same same frequencies frequencies will will be be decreased.decreased.
5. 5. SPEAKERS SPEAKERS Selector Selector
SwitchSwitch
Two Two
pairs pairs
ofloudspeakers ofloudspeakers
can can be be
connected connected
to to the the receiver.receiver.
When When switched switched to to
position position
"A" "A" only only the the
main main speakers speakers
willwill
produce produce
sound. sound. In In
the the
"B" "B" position position
only only the the
secondarysecondary
speakers speakers
will will
produce produce
sound. sound. When When
switched switched to to the the
"A+B""A+B"
position position
both both
sets sets
can can be be driven driven at at the the
same same
time. time.
ForFor
private private
listening listening
with with headphones, headphones,
the the
selector selector
switchswitch
should should
be be
placed placed
in in
the the
OFF OFF
position.position.
6. 6.
TUNING TUNING KnobKnob
For For
frequency frequency
adjustment adjustment turn turn this this
knob knob
while while
observingobserving
the the
dial dial indicator indicator and and
meters meters
7 7
and and
8.8.
1"":"J 1"":"J ;lii ;lii
i,*, i,*,
lffiTT:#'ff::::l lffiTT:#'ff::::l
;Hl,::'.i:p ;Hl,::'.i:p
*l*l
- -
AUX:AUX:
tuned tuned with with the the tuning tuning
knob. knob. The The
green green
indicator indicator
abovi abovi
ii
will will light light
up, up, then then
tuning tuning
control control
may may
be be used. used.
]"]"
13. 13. FM FM FREOUENCY FREOUENCY
Meter Meter
II
This This meter meter indicates indicates the the approximate approximate FM FM frequency frequency
re- re-
ll
ceived ceived and and is is helpful helpful
when when
pre-tuning pre-tuning
FM FM
stations. stations.
II
II
14. 14. MODE MODE
SwitchSwitch
- -
STEREO STEREO
Position: Position:
Sisnal Sisnal source source will will be be reproducedreproduced
in-normal in-normal
stereo stereo manner.manner.
- -
MONO MONO
Position: Position:
Both Both
channels channels
(R+L) (R+L)
are are mixedmixed
together together for for
a a monophonic monophonic
signalsignal
and and reproduced reproduced
by by both both
speakers.speakers.
The The
"MONO" "MONO"
position position
is is also also
useful useful for for
recording recording
andand
playback playback
with with simple simple tape tape and and
cassette cassette
decks decks that that
havehave
only only
mono mono record record
and and
playback playback
capabilities.capabilities.
To Next Page
Loading...
