nn
15. 15.
TAPE TAPE
MONITOR MONITOR
SwitchSwitch
Normal Normal
Position: Position:
SOURCE SOURCE
(Released (Released position)position)
A A cassette cassette
or or open open reel reel tape tape deck deck
can can
be be
connected connected
toto
the the
FISHER FISHER
RS-3030. RS-3030. To To use use a a tape tape
deck deck as as sound sound source,source,
the the unit unit must must be be
connected connected
to to the the
appropriate appropriate inputs inputs onon
the the rear rear
panel.panel.
Tape Tape deck deck
with with separate separate
record record
and and
playback playback
heads heads
cancan
be be
monitored monitored during during
recording recording for for rapid rapid and and
accurateaccurate
control control
during during
the the
recording recording
process process
by by switching switching toto
PLAY PLAY during during recording.recording.
16. 16.
LOUDNESS LOUDNESS
CONTOUR CONTOUR
SwitchSwitch
At At
lower lower
volume volume levels, levels, the the human human
ear ear requires requires increasesincreases
in in certain certain
frequency frequency
ranges ranges
so so that that the the reproduced reproduced
soundsound
source source sounds sounds normal. normal. The The
depressing depressing of of the the loudnessloudness
button button automatically automatically
places places
emphasis emphasis
on on the the
proper proper
fre-fre-
quencies quencies
at at low low volume volume levels. levels. For For reproduction reproduction
at at higherhigher
volume volume levels levels the the loudness loudness
selector selector should should be be
in in the the
OFFOFF
(out) (out) position.position.
17. 17.
FREOUENCY FREOUENCY
LOCK LOCK SwitchSwitch
I I
ffr" ffr"
switchable switchable
Frequency Frequency
Lock Lock control control on on the the
FM FM
bandband
ensures ensures that that
once once
a a
station station
has has
been been selected selected
it it
cannotcannot
drift drift off off tune. tune. Normally Normally it it is is
best best
to to tune tune to to a a
stationstation
with with the the
Frequency Frequency
Lock Lock switched switched
OFF OFF
(depressed(depressed
position) position)
and and
then then
switch switch
the the Frequency Frequency
Inck Inck ON ON
(released(released
position). position).
When When listening listening to to very very
weak weak
stations, stations, or or a a
weakweak
station station on on a a
similar similar
frequency frequency
to to a a
stronger stronger station, station, it it isis
often often
best best to to
push push
the the Frequency Frequency
Lock Lock
switched switched OFF OFF toto
prevent prevent
"pulling" "pulling" into into the the
stronger stronger station.station.
18. 18.
PHONESPHONES
Connection Connection
of of headphones headphones
is is
possible possible
using using a a normalnormal
ll4 ll4
inch inch
(6.35 (6.35
mm) mm)
3 3
pole pole
stereo stereo
jack. jack.
RecommendedRecommended
impedance impedance
8 8
to to
400 400 Ohm.Ohm.
Connections Connections
on on the the Rear Rear PanelPanel
1. 1. AntennaAntenna
- -
FM FM antenna antenna
connection connection
with with 75 75
ohm ohm
coaxial coaxial
cable. cable. TheThe
central central
(middle) (middle)
strand strand of of
the the
coaxial coaxial
cable cable
should should bebe
attached attached to to
the the
screw screw
terminal terminal marked marked
"75 "75
Ohm".Ohm".
The The braided braided
shielding shielding
should should be be
turned turned
back back and and thethe
whole whole cable cable
fastened fastened
with with
the the
cable cable
clamp clamp locatedlocated
directly directly to to
the the left left of of the the
75 75 ohm ohm terminal. terminal.
Please Please
seesee
figures figures
4 4 and and 6.6.
- -
FM FM
antenna antenna
connection connection
with with
300 300
ohm ohm
(flat, (flat,
two two
strand)strand)
cable. cable. Indoor Indoor
antennas antennas
("rabbit ("rabbit
ears", ears",
"T" "T" dipole, dipole,
etc.)etc.)
using using a a
flat flat
two two
strand strand antenna antenna
cable cable
should should be be
con-con-
nected nected to to
the the
two two
(2) (2)
screw screw terminal terminal
marked marked
"300"300
Ohm". Ohm".
See See
Fig.5.Fig.5.
- -
AM AM
antenna antenna connection connection
for for middle middle
and and
long long
wavewave
reception reception
is is
connected connected to to
the the
screw screw terminal terminal
markedmarked
"4M". "4M". This This terminal terminal
is is mainly mainly used used
for for
outdooroutdoor
"Long "Long Wire" Wire" antenna antenna for for long long
distance distance reception. reception.
MostMost
of of tire tire time, time,
the the ferrite ferrite
bar bar
antenna antenna
will will
be be adequate adequate forfor
most most reception.reception.
2. 2.
Ferrite Ferrite
Bar Bar AntennaAntenna
The The RS-3030 RS-3030 is is equipped equipped
with with
a a
ferrite ferrite
bar bar antenna antenna forfor
AM AM
reception reception
in in
the the
middle middle and and long long
wave wave
frequencyfrequency
ranges. ranges.
The The
antenna antenna
should should
be be folded folded
out out from from the the
chassischassis
and and
turned turned
gently gently
when when
needed needed
for for
strongest strongest
signalsignal
reception.reception.
3. 3.
Speaker Speaker ConnectionsConnections
Two Two
pairs pairs
of of loudspeakers loudspeakers
can can be be connected connected
to to thethe
RS-3030 RS-3030 (System (System
A A
and and System System
B). B). By By
depressing depressing
thethe
button button on on the the
spring spring loaded loaded
contact, contact,
the the
jaw jaw
ofthe ofthe
contactcontact
is is
opened opened and and the the
speaker speaker cable cable
can can be be inserted. inserted.
By By re-re-
leasing leasing
the the button, button, the the
jaw jaw
close close and and the the
cable cable is is
clamped clamped
inin
the the
connector connector
making making
proper proper
contact. contact.
Care Care
should should
bebe
taken taken that that
during during
connection connection of of the the
speakers speakers
properproper
polarity polarity
is is
accomplished. accomplished.
The The
+ +
terminal terminal
of of the the
speakerspeaker
shonld shonld
be be connected connected to to the the
marked marked
"LEFT" "LEFT"
or or
"RIGHT""RIGHT"
terminal terminal of of the the
receiver, receiver,
as as minus minus to to
"COM". "COM".
For For furtherfurther
help, help,
"LEFT" "LEFT" and and
"RIGHT" "RIGHT"
terminals terminals
in in
gray. gray.
For For
cablecable
lengths lengths
unCer unCer 15 15
meters meters
simple simple double double
strand strand
cablecable
(NYFAZ) (NYFAZ)
with with a a diameter diameter
of of
0.75 0.75 mm mm
is is
sufficient. sufficient. ForFor
cables cables longer longer than than
15 15
meters, meters,
cables cables
with with
a a
diameter diameter
ofof
1.5 1.5 mm mm are are recommended.recommended.
4. 4.
PHONO PHONO
InputsInputs
Connection Connection for for
turntables turntables using using
moving moving
magnet magnet
cartridgecartridge
system. system.
Turntables Turntables that that have have
a a
DIN DIN
plug plug
can can be be usedused
with with adapters adapters
that that
can can be be
purchased purchased
from from
specializedspecialized
dealers. dealers.
For For
best best results, results,
proper proper
channel channel
orientationorientation
is is
required. required.
Please Please
check check
your your
turntable turntable
instruction instruction
manualmanual
for for
instructions instructions
on on
proper proper
channel channel orientation orientation
for for
con-con-
nection.nection.
5. 5. AUX AUX
InputsInputs
Connection Connection
for for
any any
high high level level
output output
program program
sourcesource
such such as as
short short
wave wave
receiver, receiver,
television television
audio audio
signal, signal, etc.etc.
FF
To Next Page
Loading...
