5
1. Plug In • Connect the Ellipse Aura to your amplifier or PA with a ¼-inch
instrument cable.
2. Select an Image • Raise the Volume and use the Image switch to browse
through the four Images until you find one you prefer.
3. Blend in the pickup • Move the Blend slider to the left to mix in some
pickup signal with the Image.
4. Phase • Push the Phase switch in and out until you find the position that
sounds most pleasing. If feedback occurs, change the position of the switch.
5. Anti-Feedback • Start with the Volume off. Move the Anti-Feedback switch
to the On position (left). Push and hold the measure button for several seconds.
Raise the volume until feedback begins. The filter will latch onto the feedback
and eliminate it after a few seconds.
To Next Page
Loading...
Need help?
General
