Fishman PRESYS BLEND ONBOARD PREAMP - Presys Blend Quick Start

2
Presys Blend Quick Start
1. Set the controls • Set volume, mic blend and notch off. Set the bass,
middle and treble controls to center.
2. Plug in • Connect the Presys Blend to an amplifi er or PA with a ¼-inch
instrument cable. The battery light (batt) will fl ash once quickly to indicate it has
switched on.
3. Turn up • Raise the volume and adjust the bass, middle and treble controls
to your liking.
4. Mix in the mic • Raise the mic blend to mix in the onboard microphone.