9
Charging your tracker
To charge your tracker:
1. Plug the charging cable into the USB port on your computer or a UL-certified USB wall charger.
2. Press the tracker into the compartment on the charging cable The pins on the charging cable must
align with the corresponding pins on the back of the tracker and lock securely in place. You’ll
know the connection is secure when you see a light pattern on the tracker.
FPO [tracker pins aligned with charging cable pins ]
FPO [tracker going correctly into charging cable]
Charging fully takes about one to two hours. While the tracker charges, each white light that turns on
represents 25% of the maximum charge. When Flex 2 has charged completely, you’ll see a green light
and then all five lights will blink for three seconds before turning off.
Care
It’s important to clean and dry your Flex 2 regularly. For instructions and more information see
http://www.fitbit.com/productcare. Always remember to keep it clean; keep it dry; don’t wear it too tight;
and give your wrist a rest.
To Next Page
Loading...
Need help?
General
