FITLIGHT Trainer - Page 37

The Light parameters can now be selected as per requirements.
1. The deactivation distance can be set from 10 cms to 80 cms, use the +/- to adjust. The distance incre
ments are 10 cms.
2. The time out can be set from 0.10 seconds to 120 seconds. The time out increments are 0.10 seconds
up to 10 seconds , after which it increments by 10 seconds. The “Time Out” function can also be turned
off by going past 120 seconds.
3. Select Light colour as required by selecting the colour box.
4. There are 3 deactivation modes to select from. Distance only, Impact only or both, which means the
Light can be deactivated by motion or impact.
SYSTEM OPERATION - SPLIT TIME TRAINING
SYSTEM OPERATION - SPLIT TIME TRAINING
..................................................................................................................................................................................................................................
SPLIT TIME TRAINING SET UP
Select
Performance & Training
Select
Split Time Test
36
FITLIGHT Trainer™