SUPPORT
..................................................................................................................................................................................................................................
LIGHT ISSUES
FITLIGHT(s)™ does ( do ) not turn on / No Power to the FITLIGHT (s)™
1. Check that the polarities of the batteries are installed correctly, positive (+) to positive (+) / negative (-)
to negative (-).
2. Make sure that the batteries are fully charged, if unsure recharge again until the Light is green.
3. Try a different set of fully charged batteries. If the Light works it indicates that the replaced battery life
has been depleted and the batteries should be discarded according to your local disposal regulations for
batteries.
4. Make sure that the correct voltage batteries are inserted into the Lights. They should be 1.2 volts DC
5. Make sure that you are using rechargeable batteries.
6. Make sure that all of the batteries are fully charged and that there is not a weak charge battery within
the group.
7. Check that you have a good wireless connection to the Lights.
CHARGER ISSUES
The Charger does not turn on / No Power to the Charger
1. Check that there is power to the charger; make sure that the electrical outlet that the charger power
supply is connected to is functioning correctly. You can test the outlet by simply plugging a lamp or cell
phone charger into the outlet to see if it is functioning.
2. Check that the power supply is properly plugged into the wall outlet and also the Charger unit.
3. Check to make sure the small cable is not unplugged from the charging case, lift the foam in the
Charger case and check the connection of the cable.
4. Check that the power supply connection to the case cable is functional, rotate cable connection and
observe if problem is resolved.
The FITLIGHTS™ are not charging
1. Check that the Lights are correctly inserted into the Charger.
2. Make sure that there are batteries in the Lights.
3. Check that the polarities of the batteries in the Lights are installed correctly, positive (+) to positive (+) /
negative (-) to negative (-).
4. Try a different set of Batteries. If the Light charges it indicates that the replaced battery life has been
depleted and the batteries should be discarded according to your local disposal regulations for batteries.
5. Make sure that the correct voltage batteries are inserted into the Lights. They should be 1.2 volts DC
6. Make sure that you are using rechargeable batteries.
7. Make sure that there is no weak charge battery within the group by replacing one at a time.
8. Make sure that the lights are making contact with the terminals in the charger.
9. Check that the power supply connection to the case cable is functional, rotate cable connection and
observe if problem is resolved.
SUPPORT
58
To Next Page
Loading...