Flama 1319FL - Continuous Drainage

27
English
EMPTYING THE WATER TANK
When the tank is full, the dehumidier will
make a buzzing sound and the “full tank”
light will turn on.
Press the POWER buon to turn o the
dehumidier.
Pull on the water tank and simply slide it
out of the dehumidier.
Empty the water down a drain or outside.
Clean the interior and exterior of the tank.
Return the empty tank to the dehumidier.
Press the POWER buon to connue
operaon.
If the “full tank” light does not turn o,
check that the tank and the oat are
correctly posioned.
Noce
Do not discard the water tank magnets and
plasc rivets. Otherwise, the dehumidier
will not automacally stop working when
the water tank is full, and the condensed
water will overow and damage the oor
of the room it is in.
Make sure to clean the condensed water in
the water tank before restarng operaon
of the dehumidier.
If the water tank is dirty, rinse it with clean
water. Avoid using detergents, chemical
dust removers, diesel oil, benzene,
thinners or other solvents. These will
damage the water tank and cause leaks.
Return the empty tank to the dehumidier.
Otherwise, the full tank indicator will
remain red and the dehumidier cannot
restart.
CONTINUOUS DRAINAGE
For connuous operaon or automac
dehumidicaon, connect the drain hose
to the dehumidier. The condensed water
can automacally ow to a bucket or drain
by gravity.
Straighten the drainage tube.
Insert one end of the hose into the cistern
orice and connect the other end to the
bathtub, outdoors, a bucket-like recipient,
or to a designated drainage area.
How to correctly place the drainage hose
In connuous drainage mode, the hose
should be placed below the drainage
orice. Avoid uneven surfaces and do not
bend the hose.
WARNING
Do not block the drain or drainage tube.
Do not bend the drainage tube. The height
of the drain should be lower than the
outlet.
The drainage tube should be safely
connected to the outlet.