EasyManua.ls Logo

Flama 5500FL - Page 18

Flama 5500FL
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16 www.ama.pt
other than “Max”.
Press the cleaning indicator buon for 2
seconds; an audible alarm is emied.
NOTA: You should keep a distance from the
appliance during the cleaning process so
as to prevent burns by high temperature
steam.
The appliance enters into cleaning mode
and the cleaning indicator buon light
ashes. Aer approximately 3 minutes, the
cleaning is complete, and the appliance
returns to operaon mode.
The cleaning indicator buon light switches
o.
Steam shot
A shot of steam can be acvated by pressing
the steam buon twice in succession.
Connuous steam
Press the steam buon connuously for
steam ironing.
Cable organiser clip
When not in use, the power cable and the
steam supply hose can be died at the base
of the appliance, using the cable organiser
clip.
OPERATION
Before rst use
Remove any scker, protecve lm or
storage cardboard from the base.
Fill the water tank with water according to
the “Steam ironingsecon, heat the iron to
the maximum temperature and iron a piece
of damp fabric for a few minutes to remove
any residue from the base, according to the
“Steam ironing” secon.
NOTE: It is normal to smell a strange odour
coming from the appliance upon rst use.
This odour disappears quickly.
NOTE: It is possible that some parcles
leave the base when using the iron for the
rst me. This is normal. The parcles are
harmless and no longer leave the iron aer
a short period of me.
NOTE: When plugging in the appliance, the
appliance may emit a pumping sound. This
is normal. The sound indicates that water
is being pumped from the base to the iron.
NOTE: A lile steam may leave from base
during the heang process, which stops
happening aer a few seconds.
Use
The appliance has two ironing modes. Dry
ironing or steam ironing can be used.
Dry ironing
Place the appliance on a stable and level
surface.
Always place the iron on the thermal
insulaon xture.
Connect the power cable plug to the wall
socket; the appliance switches on.
Turn the temperature buon to the
intended seng, which depends on the

Related product manuals