EasyManua.ls Logo

Flame boss 500 - WiFi Setup Using Controller

Flame boss 500
27 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
20
www.FlameBoss.com
WIFI SETUP USING CONTROLLER
q or p toggles between Station and Access Point mode.
Selection Station mode and press NEXT.
q or p cycles through available local networks detected by
the controller. Select your WiFi Name and press NEXT.
Press q or p to select a character. Press NEXT to save the
character and move to the next position.
This will duplicate the last character. Press q or p to select the
next character and press NEXT to save it and move to the next
position. Repeat until all characters are entered.
At the end of your password the last letter should be
duplicated. Press q or p to select (Enter) and press NEXT
to save.
Note: If your WiFi network is using WEP security, change the
format to Hex.
After saving your password, the controller will join your
WiFi network.
WiFi Name (SSID)
> sabshomewi
fb
fb-guest
WiFi Password
Format: Text
[password123]
Enter
WiFi Mode
[Station]
WiFi Password
Format: Text
[]
Enter
Once connected, the display will show the ID & Pin of
your controller.
WiFi Status
Joining fb
Online! Visit
MyFlameboss.com
ID: 12345
Pin: 1234
q or p hides or unhides the pin in the online notice.
Hide PIN in
online notice?
[Yes]