PowerFLARM Core Manual v.150 International
• Switch system ON with BF display knob pressed.
• Verify BF display goes into UPDATE MODE with 'WAITING',
then 'LOADING'.
• Wait until BF display restarts (can take up to two minutes).
Multiple displays on separate Data Ports need to be updated se-
quentially: Press the BF display knob only on one display, then re-
peat the procedure for the other display.
Note: This procedure is only supported for displays directly con-
nected to PowerFLARM, i.e. not via a 3
rd
party repeater or Y adapter.
For Y adapters and repeaters, please consult the display and respec-
tive 3
rd
party documentation.
To Next Page
Loading...