EasyManuals Logo

Flash ART Series User Manual

Flash ART Series
34 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
3
SAFETY INFORMATION
WARNING! The Led Moving Head (LMH) has a powerful pan and lt
motor. The torque reacon when the head is panned suddenly can cause
the base to move if the xture is standing unsecured on a surface. Do
not apply power to the LMH unless the baase is securely fastened to a
surface or to rigging hardware.
WARNING! Use 2 clamps to rig the xture. Do not hang the xture from
only one clamp. Use safety chain when xes this xture. Don’t handle the
xture by taking its head only, but always by taking its base.
WARNING! When clamping the xture to a truss or other structure at
any other angle than with the yoke hanging vercally downwards, use
two clamps of half-coupler type. Do not use any type of clamp that does
not completely encircle the structure when fastened.
WARNING! Do not look directly at the light spot while the xture is on.
IMPORTANT! Do not point strong light output from other xtures at the
lamp, as intense illuminaon can damaged the display.
WARNING! Before operang, ensure that the voltage and frequency of
power supply match the power requirements of the xture. It’s important
to ground the yellow/green conductor to earth in order to avoid electric
shock. Do not touch any wire during operation and there might be
a hazard of electric shock. To prevent or reduce the risk of elec-
trical shock or fire, do not expose the fixture to rain or moisture.
Do not connect the device to any dimmer pack.
IMPORTANT! Unpack and check carefully there is no transportaon
damage before using the xture. In the event of serious operating
problem, stop using the fixture immediately. Never try to repair
the fixture by yourself. Repairs carried out by unskilled people
can lead to damage or malfunction. Please contact the nearest
authorized technical assistance center. Always use the same type
spare parts. Disconnect main power before servicing and maintenance.
The housing must be replaced if they are visibly damaged.
IMPORTANT! Maximum ambient temperature is: 40°C Don’t operate it
where the temperature is higher than this.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Flash ART Series and is the answer not in the manual?

Flash ART Series Specifications

General IconGeneral
BrandFlash
ModelART Series
CategoryLighting Equipment
LanguageEnglish

Related product manuals