7
Input Voltage AC Amperage Frequency Total Power
230 [V] 4.35 [A] 50 [Hz]
1000 [W]
110 [V] 9.1 [A] 60 [Hz]
Voltage Specycaon
IMPORTANT!
The connecon is performed using power cable with powerCON TRUE1 connector
(included). The device must be operated by qualied personnel.
CAUTION! In the case of cable damage do not aempt to repair. Replacement or
repair can be made only on the manufacturer or by a person with appropriate per-
missions
Using lamp, the change rate of power voltage should be within ±10%, if the voltage
is too high, it will shorten the light’s life; if it’s not enough, the lamp will be dark.
Please restart it aer turning o light for 20 minutes unl full-cooling. Frequent swi-
tching will reduce the life span of lamps and bulbs; intermient using will improve
the life of bulbs and lamps.
The maximum number of devices connected in series via
power cable is 3 pcs.
Set DMX Address
□ To enter the MENU enter the password (if password is turned on). The password
is UP, DOWN, UP, DOWN.
□ Find DMX on menu, and press ENTER to enter into.
□ Set needed DMX Address using the UP and DOWN buons.
□ Press ENTER to save.
□ Press the MENU to exit.
Set ArtNet cong
□ Find NET on menu, and press ENTER to enter into.
□ Go to IP ADRESS to set needed IP address (generally ArtNet works on IP range
2.x.x.x, or 10.x.x.x) on your network.
□ Go to Subnet mask to choose needed Subnet mask.
□ Go to SET UNIVERSES to give Control (master dimmer and shuer), and LED
(pixels). Do not forget that artnet is counted from universe 0.
□ Control has main addres of the lamp. The address for pixel mapping always starts
with 1. Control of Beams is on universe X, AURA on universe X+1.
□ Enjoy your lamp with pixel mapping!
To Next Page
Loading...
Need help?
General
