EasyManua.ls Logo

FLAVIA Creation 400 - Daily Care; Weekly Care

FLAVIA Creation 400
11 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGENG
GENERAL CLEANING
CLEANING THE WATER FILLER FUNNEL
CLEANING THE FILTERPACK DOOR
CLEANING THE CUP DETECT AND AIR DUCT
SANITISING
W E E K L Y C A R E
Use a damp cloth to wipe the outside surfaces and the areas that are exposed inside.
Do not use strong detergents and take care not to get soapy water into the water tank as
this will affect the drink taste
1. Open filler lid
2. Remove filler funnel assembly
3. Clean them
4. Rinse thoroughly (so no soap
gets into tank)
5. Replace
6. Close the filler flap
1. Grip bottom of filterpack door
2. Use other hand to steady the brewer.
3. Pull sharply from bottom towards you
4. Wash in warm soapy water and rinse
thoroughly
5. Wipe sides of area where door was
6. Replace door – Top first
7. Push bottom of door until you hear
a ‘CLICK’
Ensure sensor is wiped clean
and not obstructed
Ensure air duct is clean and
free of debris
After cleaning, sanitise surfaces with a non-chlorine based anti-bacterial wipe or solution.
Avoid scented products, as this will affect the drink taste.
8
Remove filterpack
door to access air
duct
7
D A I L Y C A R E
EMPTYING THE DRIP TRAY
1. Remove drip tray
2. Pull bin forward
3. Empty filterpack bin
4. Clean bin in warm, soapy
water
5. Replace bin
6. Replace drip tray
REFILLING WITH WATER (Manual fill only)
1. Lift the filler lid
2. Fill with water
3. Maximum fill level reached when the red float cap pops up
4. Close the filler flap
EMPTYING THE FILTERPACK BIN
1. Lift out and empty drip tray. CAUTION – CONTENTS MAY BE HOT
2. Separate drip tray and cup stand
3. Clean them in warm soapy water, wipe area left by drip tray
4. Reassemble and replace carefully
WARNING - HANDLE DRIP TRAY AS REF. A
The brewer does not tell you when the drip
tray is full so make sure you check it regularly
If filterpack bin fills right up, the “check bin” message will be displayed
If your FLAVIA® brewer is on a base unit, the “check bin” message will not be displayed
Only use cold water when refilling
Take care not to overfill tank
If tank runs out before water is refilled, the
display will read “ADD WATER”
If tank is overfilled water will flow out from
underneath filterpack door and into drip tray *
Take care when removing filterpack bin
The act of removing the bin resets
the bin counter - Always empty the
bin if removed
Ref. A
*
Only applies to models of brewer with an air duct fitted
Notice
Notice
Notice
Notice
Notice
Notice
70-41-2651 iss4 UK C400 User Guide.qxd:OPS Guide US CAN Amend.qxd 1/5/09 15:26 Page 20

Other manuals for FLAVIA Creation 400

Related product manuals