EasyManua.ls Logo

Fleet Power 2000 - Introduction

Default Icon
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
90-0115-00
10/97 Fltman.pm65
INTRODUCTION
This owner's manual describes the
Fleet Power Inverter/Chargers from Heart
Interface. These units perform three distinct
functions:
1. DC to AC power inverting.
2. Automatic transfer switching between
inverter power and incoming AC power.
3. Automatic 3-Stage Battery charging plus
manual battery equalizing.
4. AC to DC power converter.
• The inverters provide regulated 120 Volt
AC power and crystal controlled frequency
at 60Hz from a deep cycle battery bank in
specified watts:
FP 1000-12................1000 watts
FP 2000-12................2000 watts
FP 2500-12................2500 watts
The output is a modified sinewave and
is compatible with appliances, tools and
other 120 VAC equipment. Momentary
surge power of three times the inverter
rating is available for starting electric mo-
tors. High efficiency insures the longest
possible battery life between recharges.
• The transfer switch allows the Fleet Power
Inverter/Chargers to be connected to an
external AC source and transfer the source
through to the loads. When disconnected,
the transfer switch allows automatic switch-
ing back to the inverter.
Fleet Power Inverter/Chargers operate
as self-contained backup power systems,
just add batteries.
• Fleet Power battery chargers are electroni-
cally controlled and rated:
FP 1000-12..................50 Amps DC
FP 2000-12................100 Amps DC
FP 2500-12................130 Amps DC
They are designed to rapidly and optimally
recharge either wet* or gel* cell deep-cycle
batteries. Battery charging is accomplished
in 3 automatic stages: Bulk Charge, Accep-
tance Charge and Float Charge. In addition,
using the remote control, a manually-en-
gaged Equalizing Charge cycle is possible.
With an external AC source connected,
the Fleet Power charger also serves the
functions of a AC to DC converter to supply
all of the DC loads which are connected to
the battery.
Simple, automatic operation is made
possible by the microprocessor in the Fleet
Power Inverter/Chargers. In most cases, the
unit is left on and no attention or mainte-
nance is required.
*Adustable with optional remote
4

Related product manuals