L,V,NG
W,TH
YOUR
MOTOR
HOME
Closets may be equipped with 12-volt lights that turn ON
when the closet door is opened. Be sure the light goes OFF
when the closet door
is
closed-your
battery will be dis-
charged
if
it stays ON.
If
the light stays on when the door is
closed, the door switch requires adjustment. The same loading
considerations apply to interior storage areas
as
to exterior.
Consult the
Motor Home Loading section in the On The
Road
chapter.
The materials used inside your motor home have been se-
lected for durability and comfort. With reasonable care, these
materials will stand up under years
of
recreational living. The
Maintenance chapter in this manual outlines care require-
ments for the various upholstery fabrics, floor, cabinet, and
wall finishes.
To
convert the dinette into a bed:
1.
Unfasten and remove cushions.
2.
Remove front and rear dinette seat rails.
3. Reach under the table. Either remove leg
or
fold it up under
the
table top.
4.
Raise the front portion of table several inches to disengage
inserts from the
wall supports.
5.
Lower table top to the dinette frame to complete bed base.
6.
Slide seat and back cushion into place over bed base.
To
convert a sofa/lounge into a bed:
1.
Lift front of sofa frame up and out.
2.
Push the back of the sofa back and down.
3.
Push the seat belts through the space between the sofa back
and seat.
PACE
ARROW
-
CopYRiqHT
1996,
FlEETWood
ENTERPRisES,
INC.
All
RiqHTS
RESERVEd.
INTERIOR
AND
FURNISHINGS
DINETTE
CONVERSION
To Next Page