PLUMBINC
SYSTEMS
Dirt, mineral scale, and organic matter are filtered out
of
the
fresh water system by an in-line water filter on the inlet side
of
the water pump.
If
you suspect a clogged filter, it is easily
removed and cleaned.
Inspect the filter after running the first full tank
of
water.
Clean and inspect monthly thereafter.
1.
Loosen the clamp at the inlet end of the filter.
2.
Pull the water line off the filter.
3. Unscrew the filter from the water pump.
4.
Turn each end of the filter and pull apart.
5.
Flush out and clean screen.
6.
Reverse procedure to install.
7.
Operate the water pump and check for leaks.
To
drain
hot
and
cold lines:
1.
Open hot and cold valves at the external utility compartment.
2.
Depress the shower handle until all water has drained from
the
lines.
WATER
FILTER
Low
POINT DRAINS
PACE
ARROW
- CopYRiqlif 1996, FiEErwood
ENfERPRisES,
INC.
All
RiqlifS
RESERVEd.
To Next Page
Loading...
