PLUMBING
SYSTEMS
To
disconnect the city water:
1.
Turn OFF the city water supply.
2.
Remove the hose from the city water supply valve.
3.
Drain and store the hose.
The on-board
fr,esh
water tank can be filled in two ways:
(1) city water pressure or (2) gravity.
1.
City water pressure - When connected to the city water
supply as described above, open the tank fill valve and
remove the fresh water tank
fill cap and vent plug.
Make sure the external gravity fill connection is open (remove
the cap) to
allow air to escape from the on-board tank. When
water
flows out of this external fill, the on-board tank is
fUll.
After filling, close the valve, replace the tank fill cap and vent
plug.
2.
Gravity
fill-The
external gravity water fill
is
located
on
the
exterior of the motor home. The on-board water tank can be
filled here.
To
fill the fresh water tank, remove the cap,
re-
move the vent plug, and fill the tank using a potable water
hose.
Check the monitor
panel often to determine if the tank is full.
If
water
is
flowing from the top vent, your tank is full. Stop
filling. Replace
the vent plug and filler cap.
FILLING
THE
ON,BoARD
WATER
TANI<
CAUTION
Overfilling the fresh
water tank
from
a
pres-
surized source will
cause serious
damage
to the water tank or
structural components.
Monitor water tank
fill-
ing
continually.
PACE
ARROW
- CopYRiq/n 1996,
FlEETWood
ENTERPRisES,
INC.
All
Riq/ns
RESERVEd.
To Next Page
Loading...
