LP
Gas
System
5. Lightly fan the area around the detector/
alarm to insure complete dispersion
of
the
gas from the lighter. and to prevent
another sounding
of
the alarm.
6. A silence button allows you to temporarily
quiet the alarm for
60 seconds after it has
been
set off or after testing.
7.
If
the alarm does not sound during a test or
if
the green indicator light
is
not visible,
see your dealer
or
an authorized Fleetwood
Service Center. There are no batteries or
user serviceable parts inside the unit.
A WARNING
The
LP
gas
leak detector/alarm
will
not function
if
both battery disconnects
are
OFF.
.II
NOTE I
The
detector/a/arm draws enough current
to
dis-
charge your battery. Remember
to
turn off
the
chas-
sis and house battery disconnects
if
you are not using
your motor home.
09-4
LIGHTING
LP
GAS APPLIANCES
Detailed operating information for the LP gas
appliances can be found in your
Owner's
Information Package. Please read and follow
these instructions.
Air
trapped in the gas lines may delay the initial
lighting
of
any appliance.
It
could take several
seconds or minutes for the gas to reach the
appliance.
To
purge some
of
the air from the gas
system, first light a burner on the range. The
other appliances will then light more quickly.
The first time the furnace or oven
is
operated,
paints and oils used in its manufacture may gen-
erate some smoke and fumes.
If
this occurs,
open doors and windows to air out the motor
home. These materials should burn off after the
first
15
to 20 minutes
of
appliance operation .
Always follow the appliance l1tanufactnrer's
lighting, operating
and
lIIaintelUlnce instructions.
A WARNING
The
LP
gas detector/alarm
is
powered
by
a 12-volt
source. Any interruption
in
power
will
render this
alarm inoperative. Always ensure power
is
applied
especially when appliances
are
in
use.
1---
f---
To Next Page
Loading...
Need help?
General
