Flex DD 2G 18.0-EC User Manual

DD 2G 18.0-EC / PD 2G 18.0-EC / IW 1/2" 18.0-EC / ID 1/4" 18.0-EC
24
Tool change
CAUTION!
Before carrying out any work on the power
tool, move the direction preselector switch (2)
to the middle position.
IW 1/2“ 18.0-EC:
 Push adapter on square drive of impact
driver (1.).
 Insert tool in adapter (2.).
ID 1/4“ 18.0-EC:
 Pull tool lock forwards (1.) and press in
the tool all the way (2.).
 Release tool lock.
 To remove the tool, pull tool lock
backwards (3.).
Inserting/replacing the battery
 Press the charged battery into the power
tool until it clicks into place.
 To remove, press the release button (1.)
and pull out the battery (2.).
CAUTION!
Protect the battery contacts when the
battery is not being used. Loose metal parts
may short-circuit the contacts –
Explosion and fire hazard!
Battery state of charge
 Press the button to check the state of
charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.

Flex DD 2G 18.0-EC Specifications

General

Brand	Flex
Model	DD 2G 18.0-EC
Category	Drill
Language	English