11
SD 5-300 4.0
Safety instructions for Li-ion
batteries
WARNING!
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions
may result in electric shock, fire and/or serious
injuries. Save all warnings and instructions for
future reference.
Do not open the battery. There is a risk of
a short-circuit.
Protect the battery from heat, e.g. from
continuous exposure to sunlight, re,
water and humidity. There is a risk of
explosion.
If the battery is damaged or used
improperly, fumes may be emitted.
Provide fresh air and consult a doctor if
you feel unwell. The fumes may irritate the
respiratory tract.
Under abusive conditions, liquid may be
ejected from the battery; avoid contact.
If contact accidentally occurs, ush with
water. If liquid contacts eyes, additionally
seek medical help. Liquid ejected from the
battery may cause irritation or burns.
The battery voltage must match the
battery charging voltage of the battery
charger. Otherwise there is a risk of re and
explosion.
Integrated batteries may only be
removed for disposal by qualied
personnel. Opening the housing shell can
destroy the power tool.
Noise and vibration
The noise and vibration values have been
determined in accordance with EN 62841.
The A evaluated noise level of the power tool
is typically:
–
Sound pressure level L
pA
: 50.97 dB(A);
–
Sound power level L
WA
: 61.97 dB(A);
–
Uncertainty: K = 3 dB.
Total vibration value:
–
Emission value a
h
: <2.5 m/s
2
–
Uncertainty: K = 1.5 m/s
2
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a measurement method
standardised in EN 62841 and may be used
to compare one tool with another.
It may be used for a preliminary assessment
of exposure. The specified vibration emission
level represents the main applications of the
tool.
However, if the tool is used for different
applications, with different cutting accessories
or poorly maintained, the vibration emission
level may differ.
This may significantly increase the exposure
level over the total working period.
To make an accurate estimation of the vibration
exposure level, it is also necessary to take into
account the times when the tool is switched off
or running but not actually in use.
This may significantly decrease the exposure
level over the total working period.
Identify additional safety measures to
protect the operator from the effects of
vibration such as: maintain the tool and the
cutting accessories, keep the hands warm,
organisation of work patterns.
CAUTION!
Wear ear defenders at a sound pressure above
85 dB(A).
Technical data
Tool SD 5-300 4.0
Type Screwdriver
Rated voltage Vdc 4
Battery capacity Ah 2
Rated No-load
Speed
RPM 300
Maximum
Torque
Nm 5
Weight kg 0.28
Working
Temperature
10-35℃
Storage
Temperature
0-40℃
Charging
Temperature
5-40℃
To Next Page
Loading...
Need help?
General
