Need help?Do you have a question about the Flex SMS 190 18.0-EC and is the answer not in the manual?
General| Idle speed (max) | 5500 RPM |
|---|---|
| Cutting depth (90º) | 66 mm |
| Cutting width (90°) | 245 mm |
| Miter setting (left) | 48 ° |
| Input power | 18 W |
| Power source | Battery |
| Battery capacity | 8 Ah |
| Bevel type | Double bevel |
| Motor type | Brushless |
| Blade bore | 30 mm |
| Blade diameter | 190 mm |
Weight and Dimensions| Depth | 575 mm |
|---|---|
| Width | 720 mm |
| Height | 400 mm |
| Weight | 12900 g |
Explains manual symbols (Warning, Caution, Note) and tool icons.
Covers essential safety, intended applications, and initial mitre saw safety.
Details on workpiece support, cutting motion, and blade engagement.
Procedures for workpiece inspection, clamping, blade speed, and cutting motion.
Specific warnings related to laser, machine signs, and operating without standing.
Covers guard operation, cleaning, handling, and blade safety precautions.
Details on noise/vibration levels and necessary precautions.
Recommended temperature ranges for operation and storage.
Table detailing cutting capacities for various mitre and bevel angles.
Lists and describes the main components of the mitre saw.
Instructions for unpacking, checking parts, and listing necessary tools.
Guides for securely mounting the saw on a surface or stand.
Steps to install the carrying handle for easier transport.
How to use the dust port and the work clamp for secure cutting.
Instructions for unlocking the saw arm, battery replacement, and blade installation/removal.
Procedures for checking and adjusting mitre angle scales for accuracy.
Steps to set and verify 45° and 0° bevel angles for accurate cuts.
Explains the different positions of the mitre-control lever for setting angles.
Procedures for setting bevel angles and adjusting the mitre-control lever.
Adjusting sliding fences, setting cutting depth, and using controls.
Using the laser for accurate cuts and general operation instructions.
Procedure to verify the proper function of the lower blade guard.
How to perform straight and angled crosscuts, with or without sliding function.
Instructions for making bevel cuts and combined mitre/bevel cuts.
Instructions for cutting grooves and preparing the saw for transport.
Safe lifting methods, routine maintenance, and repair information.
Information on obtaining spare parts and proper tool disposal.
Guidelines for disposing of batteries and electronic tools.
Statement regarding manufacturer's liability and compliance declarations.
To Next Page
