Flex XC 3401 VRG - Operating Instructions; Initial Setup and Preparation; Switching the Polisher On and Off

Polisher XC 3401 VRG
17
Operating instructions
t^okfkd>
Before carrying out any work on the
polisher, always pull out the mains plug.
Before switching on the polisher
Unpack the polisher and check that there are
no missing or damaged parts.
If required:
Remove the bail handle
Attaching the handle cover only
1. Using the hexagon-socket key (10),
remove the 2 screws from the bail handle.
2. Remove bail handle and handle cover.
3. Push on handle cover only.
4. Attach handle cover with the 2 slotted
screws.
Switch on and off
Brief operation without engaged
switch rocker:
– Press and hold down the switch.
– To switch off, release the switch.
Continuous operation with engaged
switch rocker:
– Press and hold down the switch.
– To lock into position, hold down the locking
button and release the switch.
– To switch off, briefly press and release
the switch.
klqb
Following a power failure, the switched
on power tool does not restart.