Polisher XC 3401 VRG
11
Preselecting the speed
– To set the operating speed, move the
dial (9) to the required value.
– Gently press the switch (7) to
accelerate the power tool up to the
preselected speed.
!NOTE !
If an overload or overheating occurs during
continues operation, the power tool auto-
matically reduces the speed until the
power tool has cooled down adequately.
Attach or change tools
1. Pull out the mains plug.
2. Firmly press polishing material,
centred on the eye, onto the Velcro
pad (11).
Use undamaged polishing
tools only.
3. Insert the mains plug into the socket.
4. Switch on the polisher (without
engaging it) and run the polisher for
approx. 30 seconds. Check for
imbalances and vibrations.
5. Switch off the polisher.
Operating informations
CAUTION
When the polisher is switched off, the
polishing tool continues running briefly.
!NOTE !
Following a tool change (e. g. wool pad
instead of polishing sponge), the
difference in weight may increase the
vibrations. Change the operating speed
with the adjusting wheel (9) until the
vibrations have been reduced.
– Switch on the machine before
placing it
on the surface which is to be polished
and run the polisher up to the set
speed.
– Applying light contact pressure, move
the polisher in circular, overlapping
movements on the surface which is to
be polished in order to obtain a good
polishing finish and to ensure that the
tool has a long service life.
– On sensitive surfaces (e.g. car
paintwork) do not work aggressively
but work at slow speeds applying low
contact pressure.
To Next Page
Loading...
Need help?
General
