Polisher XC 3401 VRG
10
Operating instructions
DANGER
Before carrying out any work on the
polisher, always pull out the mains plug.
Before switching on the polisher
Unpack the polisher and check that there
are no missing or damaged parts.
If required: Remove the bail handle
Attaching the grip cover only
1. Using the hexagon-socket key, remove
the 2 screws from the bail handle.
2. Remove bail handle and grip cover.
3. Push on grip cover only.
4. Attach grip cover with the 2 slotted
screws.
Switch on and off
Brief operation without engaged
switch rocker:
– Press and hold down the switch.
– To switch off, release the switch.
Continuous operation with engaged
switch rocker:
– Press and hold down the switch.
– To lock into position, hold down the
locking button and release the switch.
– To switch off, briefly press and release
the switch.
!NOTE !
Following a power failure, the switched on
power tool does not restart.
To Next Page
Loading...
Need help?
General
