Flex XFE 7-15 125 User Manual

XFE 7-15 125 / XFE 7-15 150 / XCE 10-8 125
18
Instructions for use
WARNING!
Before carrying out any work on the
polisher, always pull out the mains plug.
Before switching on the polisher
Unpack the polisher and check that there
are no missing or damaged parts.
Attach or change tools
 Pull out the mains plug.
 Firmly press polishing tool, centred on
the eye, onto the Velcro pad (8). Use
undamaged polishing tools only.
 Insert the mains plug into the socket.
 Switch on the polisher (without engaging
it) and run the polisher for approx. 30
seconds. Check for imbalances and
vibrations.
 Switch off the polisher.
Switch on and off
Brief operation without engaged switch
rocker
 Press and hold down the switch.
 To switch off, release the switch.
Continuous operation with engaged
switch rocker
NOTE
The electric power tool features a starter
interlock. In other words, the electric power
tool will not start running again if still swit
-
ched on after a power failure.
Switching on electric power tool after
a power failure
– Switch off the electric power tool.
– Switch on the electric power tool again.
 Press and hold down the switch.
 To lock into position, hold down the
locking button and release the switch.
 To switch off, briefly press and release
the switch.
Preselecting the speed

Flex XFE 7-15 125 Specifications

General

Brand	Flex
Model	XFE 7-15 125
Category	Sander
Language	English