16
10.2 Service/maintenance - CVR 2000 / CVR 3000 / CVR 4000
Dust
container
Should be emptied
before the container is
3/4 full, depending on
use but normally 2-4
times a year.
Poor suction and
danger of creating
a blockage in the
pipe system.
Release the two handles clamping the dust container. The handles
are easily unlocked by lifting up the handles until they come to a
stop. When you pull the handles outwards away from the cleaner,
the container is released. Lift off the container. Lift out dust bag
and. Empty the container in a plastic bag and put in dustbin. Any
remaining dust or fluff can be removed manually.
Dust bag
Should be replaced
before it becomes
completely full,
depending on use but
normally 2-4 times a
year.
Poor suction and
danger of creating
a blockage in the
pipe system.
Release the two handles clamping the dust container. The handles
are easily unlocked by lifting up the handles until they come to a
stop. When you pull the handles outwards away from the cleaner,
the container is released. Lift off the container. Lift out the filter.
Then remove the dust bag by pulling the bag’s cardboard stiffener
off the nozzle. Replace in reverse order.
Should be shaken when
the container is emptied.
NB: Only use dry
cleaning methods
To maintain good
suction power.
Filter
Release the two handles clamping the dust container. The handles
are easily unlocked by lifting up the handles until they come to a
stop. When you pull the handles outwards away from the cleaner,
the container is released. Lift off the container. Do not remove the
filter from the container. Instead, give the filter a light shaking inside
the container to loosen dust from the filter and allow it to fall into
the container. Lift out the bag filter. If a dust bag is being used -
remove it. Then empty the dust from the container in a plastic bag
and put in dustbin.
Should be replaced
before it becomes
completely full,
depending on use but
normally 2-4 times a
year.
Poor suction and
danger of creating a
blockage in the pipe
system.
Dust bag
Grasp the edge of the lid and open it by pulling upwards. Remove
the old dust bag by turning the cardboard stiffener to the right or
left so that the elevation on the nozzle penetrates the opening in
the cardboard. Now slide the bag off the inlet. Push the opening in
the cardboard over the elevation on the inlet and pull on the new
bag. Twist the cardboard to lock the bag in place. NB! The opening
in the card must be adjusted and pushed past the elevation on the
inlet before the cardboard can be locked into place with a twisting
action. Note: Never vacuum without a dust bag installed.
Filter in
bottom
Should be checked when
changing the bag.
Poor suction can
result. Dust can find
its way into
the motor.
10.1 Service/maintenance - CVR 1000
Remove the dust bag as described above. Remove the filter from
the bottom. The filter can be cleaned by shaking it or washing it in
water. NB! The filter must be completely dry before being reinstalled.
Replace the cleaned filter in the machine. Press the outer edge of
the filter down against the sides of the container so that the filter
bulges up slightly. Refit the dust bag and replace the lid. Check that
the lid is sitting firmly in place. Note: Never vacuum without a filter
installed.
Product How often? Why? How?
Product How often? Why? How?
NB! Never vacuum without a filter and a dust
bag installed
To Next Page
Loading...